Heater isn’t Working: Why and What To Do?
Although HVAC systems work non-stop to keep our homes warm, they are not without defects. A faulty thermostat or a tripped breaker can require heating replacement in Cambridge, ON sooner than expected. Fortunately, there are only a few simple solutions. Continue reading to learn more about how to resolve this perplexing system problem.
Try the following solutions:
Change the filter
Filters that are unclean or clogged are the most prevalent causes of furnace problems, leading to high operating costs. The heat exchanger may overheat and shut down unexpectedly when filters are blocked. If this is happening to you, the filter should be replaced.
Pleated filters should be inspected once a month, and flat filters should be changed at least once or more frequently if you have pets or children. If you can not see the light clearly through the filters, it’s time to call a professional like heater repair Rockwood.
- Ensure the thermostat is on “heat” mode
- Check to see whether your thermostat is adjusted correctly.
- Set the thermostat to a temperature that will activate the furnace.
- Allow a minute for the fan & heat to turn on after you’ve selected the setting to your liking.
- Set the thermostat to 90 degrees Fahrenheit if it doesn’t come on, so it doesn’t turn on and off while you’re attempting to figure out what’s wrong. If your thermostat isn’t working, examine the cables back to the furnace for any breakage.
Unusual odor
You shouldn’t be able to smell anything in the air if your heating system isn’t operating. If you do, it could be a symptom of a gas leak, which could put your life in danger. If you detect a gas or smoke odor, contact an HVAC specialist like heating replacement Cambridge, ON right once.
Leaking gas, on the other hand, isn’t usually visible. As a result, carbon monoxide and smoke detectors should be installed. Because this gas has no odor, identifying a leak is difficult. Remove everyone from your home and notify your local fire department if your carbon monoxide alarm goes off.
Refrigerant levels are low
Is it possible to heat your home using a heat pump? It’s conceivable that your refrigerant level has dropped too low if you are. When this happens, your heat strips may turn on more frequently than you wish. Heat strips cause high utility bills; therefore, it may be time to increase your refrigerant charge.
The compressor may overheat and malfunction if the level is too low for too long. Replacing your compressor is far more expensive than recharging the refrigerant (and fixing any leaks) (and dealing with having no heat).
Drain lines should be flushed
Your furnace can drain several gallons of water each day during the heating season. The furnace will shut off if the drain lines are clogged with sediment or mold. If the drain hose appears to be unclean, remove it and fill it with a bleach-water solution.
Heater difficulties can strike anyone and under the most inconvenient circumstances. B.A.P. Heating & Cooling Services can help if you are looking for a heater repair Rockwood to resolve your heater’s issue. Call us at (647) 250-0619 or drop us an email here to know more.